How to fit a VentureShield

If you’ve bought a VentureShield to fit to your helmet to protect the paint work but are unsure how to fit it, here are four simple steps to getting the best fit.

1. Remove visor and make sure the helmet surface is clean.

2. Using the solution, spray the area of the helmet where the material will be affixed. Peel the material from the backing paper while spraying the adhesive side of the material with the solution.

3. Spray the face of the material with the solution and working outwards with the squeegee, use short strokes to remove any fluid and air bubbles; this will secure the film in place.

4. Continue working the film until all the areas are secured. Dry off any excess fluid

Visit www.phoenixnw.co.uk or call 01782 569800 for more details on the helmet paint-saver.